washing machine not filling with water

Garblex home solutions kenya

Washing Machine Not Filling With Water? Here’s What to Check First

If your washing machine is running but no water is entering, don’t panic yet. This is a very common issue in many Kenyan homes, and in most cases, the fix is simple.

Before calling for washing machine repair in Nairobi, go through these steps—you might save time and money. Call a washing machine technician at 0727077723

Common Causes of No Water in Washing Machine

1. No Power (Yes, It Happens More Than You Think)

It may feel obvious, but many washing machine problems in Kenya are caused by power issues.

  • Make sure the machine is properly plugged in
  • Check if the socket is working
  • Inspect your circuit breaker—it might have tripped due to overload

👉 Quick test: Try running a spin cycle. If it works, power is fine—move to the next step.

2. Water Supply Is Turned Off

This is another very common issue, especially after plumbing work or water shortages.

🚰 Check Your Water Valves

  • Lever-type valves → Ensure the handle is aligned with the pipe (fully open)
  • Round handles → Turn them anti-clockwise until fully open

Also check:

  • Main water supply to the house
  • Water heater valves (for hot water supply)

💡 Tip: In many Nairobi homes, water interruptions are frequent—always confirm supply first.

3. Blocked or Dirty Filter Screens

This is one of the top causes of washing machine not filling with water in Kenya, especially in areas with hard water or borehole supply.

How to Fix It:

  • Turn off water supply
  • Disconnect the inlet hoses
  • Check and clean the small filter screens inside
  • Remove dirt, الرمل (sand), or mineral buildup

If badly damaged, replace the screens.

💡 This issue is very common in places like Ruiru, Kitengela, and outskirts of Nairobi due to sediment in water.

4. Faulty Lid Switch (Top Load Machines)

Your machine may refuse to fill if it thinks the lid is open.

👉 Quick test:

  • Run a spin-only cycle
  • If it runs → lid switch is fine
  • If it doesn’t → the switch could be faulty

This is a frequent issue in older machines and often requires professional washing machine repair services in Nairobi.

5. Water Inlet Valve (Solenoid) Problem

This is one of the most common technical faults.

The inlet valve controls water entering the machine. If it fails:

  • Machine may fill slowly
  • Only hot or cold water may work
  • Or no water at all

How to Check:

  • Try cold water only → if no water, cold valve may be faulty
  • Try hot water only → same logic applies

If both fail, the solenoid valve likely needs replacement.

⚠️ This repair usually needs a technician. call technician 0727077723

6. Water Level Sensor / Pressure Switch Issue

Sometimes your washing machine thinks it’s already full—even when it’s empty.

This happens when:

  • Pressure switch is faulty
  • Pressure hose is blocked

What to Do:

  • Locate the small rubber tube connected to the sensor
  • Blow through it gently to clear any blockage
  • Check for dirt or detergent buildup

If blocked, the machine won’t allow water in.

7. Faulty Control Board (Advanced Issue)

If everything else checks out, the problem could be the main control board.

  • This is more common in modern digital washing machines
  • Repair or replacement can be costly

👉 Best to consult a qualified washing machine technician in Nairobi before replacing it.

When to Call a Professional in Kenya

If your washing machine still has no water after all these checks, it’s time to get expert help.

✅ Recommended Service:

Garblex Home Solutions – Reliable Washing Machine Repair in Nairobi

They specialize in:

  • Washing machine not filling with water
  • Inlet valve replacement
  • Drainage and spinning issues
  • Full diagnostics and repair

📞 Call: 0727077723 website: Garblex Home Solutions

Uncategorized